Datamax DGL - Page 51

51
BACK AFTER PRINT When the present distance is
set with the cutter, present
sensor or GPIO option
enabled, this setting
determines the timing of the
label back up.
ENABLED, *DISABLED
N/A
MENU LANGUAGE Selects the language in which
the menu system messages
and configuration label are
shown.
PRINTER CONTROL
→
Display
Language
FAULT HANDLING LEVEL
*1
2
VOID DISTANCE
*0.25in (0-2.00)
RETRY COUNT
*1 (0-3)
When a faulted condition
(ribbon or paper out, failed
bar code, etc.) has been
detected, this setting
determines the action to be
taken by the operator and the
printer.
N/A
Table 4. System Settings Menu
Datamax Setting Description PTX Setting
Table 5. Communications Menu
Datamax Setting Description PTX Setting
SERIAL PORT A
SERIAL PORT B
Controls the communications
settings for the Serial Ports.
SERIAL PORT
PARALLEL PORT A
PARALLEL PORT B
Controls the communications
settings for the Parallel Ports.
PARALLEL PORT
NIC ADAPTER Controls the communications
settings for the Ethernet
Ports.
ETHERNET PORT /
ADDRESS / PARAMS
HOST SETTINGS Settings which affect all
communications with a host
HOST TIMEOUT The number of seconds a
communications port must be
idle before the printer may
process data from a different
port.
*10 SEC (1-60)
All communication port
menus
→ Timeout
*10 Sec (1 – 60 Sec)