Datamax Mark II M-4206 Operation Instructions

Additional Information 16
8. The IP Address assigned to the printer can be viewed on
the Wireless Report.
To print the ‘Wireless Report’:
a. Press the PAUSE, FEED, CANCEL buttons at the
same time.
The information on this label will vary depending on your
configuration and firmware version.
Once the previous steps have been successfully completed you may now use the IP Address to:
> Install a printer driver, and start printing from your Windows
®
applications. See section, Installing the Printer Driver.
-or-
> Browse to the printer’s internal web pages to print test labels or configure network settings such as assigning a new IP
address or SSID to the printer and enabling/configuring wireless security protocols. See section, Browsing to the
Printer’s Internal Web Pages.

Datamax Mark II M-4206 Specifications

General

Print Resolution	203 dpi
Type	Label Printer
Print Method	Thermal Transfer
Max Print Speed	6 inches per second
Memory	16 MB SDRAM, 8 MB Flash
Interfaces	USB, Serial, Parallel
Media Width	4.5 inches
Media Length	0.25" to 99"
Max Print Width	4.25 inches (108 mm)