Wireless Network Setup 5
Wireless Network Setup
It is recommended that the printer’s communication settings be reset to factory defaults to avoid any conflicts in
configuration. To reset the printer’s communication settings:
;
Note: Non-display printer users should skip this reset procedure.
1. Turn on the printer and press the MENU BUTTON.
2. Using the DOWN BUTTON scroll to ‘COMMMUNICATIONS’ and press the ENTER KEY.
3. Using the DOWN BUTTON scroll to ‘NIC ADAPTER’ and press the ENTER KEY.
4. Using the DOWN BUTTON scroll to ‘SET FACTORY DEFAULTS’ and press the ENTER KEY. When prompted
press the YES KEY. The printer with then reset and return to Ready Mode.
At this point it is recommended to print a Wireless Report. This Wireless Report is generated by the printer and lists
important default information such as the IP Address and SSID.
To print the ‘Wireless Report’:
1. Press the PAUSE, FEED, CANCEL buttons at the same time.
The Wireless Card can be configured via a wireless Adhoc connection or using the Datamax Printer Configuration Utility
(DMXConfig) via a serial or parallel connection. The procedures for each are listed in the following sections.
To Next Page
Loading...
Need help?
General
