DNS-1640 User Manual
Before You Begin
Important:
Before you set up the DNS 1640 system, be sure your facility meets the following
conditions.
C
onfirm that there is adequate power at your facility to support the high-availability features of the system.
It is recommended to connect each power connector to separate power circuit.
If necessary refer to the documentations shipped with the 6Gb/s SAS HBA/RAID card for hardware and
driver installation instructions
There are different types of SAS Cables in the market, make sure you order the right one for DNS-1640.
For DNS-1640, it all uses SFF-8088 to SFF-8088 SAS Cable when connecting DNS-1640 to host and when
daisy chain to another DNS-1640.
SFF-8088 to SFF-8088 SAS Cable
To Next Page
Loading...
