3. SPECIFYING THE SYSTEM
It is critical the correct alarm system is chosen to suit the customers’
requirements. Please note that this system is not an insurance-
approved product, if insurance approval is an important criteria for
your customer then you should look to install a Datatool S4 Series
alarm or equivalent. Scorpion Automotive Ltd cannot be held
responsible for incorrect choice of product or costs incurred removing
an incorrectly specied alarm.
If you require further assistance in choosing the correct alarm system
then please contact info@datatool.co.uk with details of the
motorcycle/scooter requiring the alarm.
This alarm system is intended for use on motorcycles or scooters, with
or without a factory immobiliser system. The Datatool Evo Plus has the
following specication:
Single engine immobiliser circuit – suitable for use on ‘normally
open’ or ‘normally closed’ vehicle circuits
Movement sensor (3 level adjustment)
Panic facility via remote control
PIN override (factory set, non-adjustable) suitable for key or keyless
ignition vehicles
Check status LED
Seat/panel switch
Automatic arm / re-arming (Selectable, re-arms alarm if disarmed by
remote and ignition is not switched on)
Arm/disarm chirps (Selectable when arming or disarming)
Bike nder via ashing indicators or side lights (depending on
installation)
Additional negative output to trigger secondary device (e.g. pager)
System memory (remembers the last state in which it was left if the
battery is disconnected)
4. CONFIGURING THE ALARM TO SUIT THE CUSTOMERS’
REQUIREMENTS
Due to the design of the EvoPlus series it is possible to congure the
system in several ways. It is advisable to discuss the options available
with the customer prior to installing the system. Some of the features
To Next Page
Loading...