Datatool S4 - User Manual

USER GUIDE

Summary

Remote control battery maintenance

Changing the remote battery

Operating the alarm system

Arming the system

Details passive arming after ignition off and fully arming the system.

Fully arming the alarm

How to fully arm the system for maximum protection.

System fault diagnosis and recovery

Disarming after trigger

Procedure for disarming the system after an alarm event.

Diagnostic chart

Automatic re-arming

Special modes and features

Panic;locator feature

Winter mode

Entering;Exiting Winter mode

PIN override system

Entering a new PIN code

Step-by-step guide to initialize and set a new 4-digit PIN code.

PIN management

Changing your PIN

Instructions on how to change the existing PIN code.

Disarming with PIN

PIN entry procedure

Detailed steps to disarm the system using the PIN code.

Incorrect PIN entry

Remote control management

Adding extra remote controls

Procedure to add up to six remote controls to the alarm system.

Removing lost;stolen remotes

Procedure for dealers to remove lost or stolen remote controls.

System customisation

Software switch operations

Changing the siren tone

Arming settings customization

Passive arming settings

How to configure passive immobiliser or full passive arming.

Removing machine battery

Dealer selectable features

Feature list and settings

Battery safety and compliance

Battery care and disposal

Safety notices on handling, care, and disposal of batteries.

Datatool S4 Specifications