Always plan the physical position for all the alarm components prior to
installation. If there is any doubt on panel t, ALWAYS temporarily
mount the unit and ret the panel prior to wiring the alarm. Once the
alarm has been installed it may be impossible to move the position to
a new location. A few moments spent checking at this point can save
several hours of re-working.
Cable Tie Mounting Technique
LED MOUNTING METHODS & POSITION
Where possible the position of the system LED should be agreed with
the owner prior to installing. The LED is the effectively rst line of
protection and should be mounted in a highly visible position to
ensure maximum deterrent effect. Installation options are shown
below:
The LED with Bezel may be mounted through an inner fairing panel or
even mounted through a light lens into a tail light unit. Warning:
When tting into an LED tail light take care not to damage the
internal rear light circuit board.
8. PLANNING THE WIRING
Where applicable, the method of immobilisation for the machine
should be selected and the wiring congured accordingly.
To Next Page
Loading...
