DATATRAC 400H User Manual

DATATRAC 400H Setup Instructions To Clear GPS NVM
Contents
Set up of the Data track ................................................................................................................................ 1
Transmitter SETUP ........................................................................................................................................ 1
Receiver SETUP ............................................................................................................................................. 2
Label setup .................................................................................................................................................... 3
Bus setup ...................................................................................................................................................... 4
End of Procedure .......................................................................................................................................... 4
Set up of the Data track
Transmitter SETUP
1. Switch On/Off: ON
a. Press “XMT” Key
b. Press “ENTER” Key
i. “TRANSMITTER SETUP” page displays
2. On the “TRANSMITTER SETUP” page
a. On/Off: ON
b. Bus speed : 100
c. Function: KEY
d. Equipment ID: 000
e. Data Format: HEX32
f. Display Lines: 03
Note: Use “^””v” to move to next/previous line
Use “>” To step through options

DATATRAC 400H Specifications

General

Brand	DATATRAC
Model	400H
Category	Measuring Instruments
Language	English

Summary

Set up of the Data track

Transmitter SETUP

Configure transmitter settings including power, bus speed, equipment ID, data format, and display.

Receiver SETUP

Receiver SETUP

Configure receiver settings: channel, power, bus speed, labels, equipment ID, data format, interval, and display.

Label setup

SELECT LABEL SETUP

Procedure to enter and manage labels for data tracks, including adding and erasing entries.

Bus setup

SELECT LABEL PAGE #2

Configure bus settings, entering specific hex data values for labels, SDI, SSM, Par, and Msec.

End of Procedure