Datavideo DAC-2 Quick Setup

DAC-2 Quick Setup with Adobe Premiere 6.5 on Windows
This setup guide will cover four specific areas:
A. Explanation of front panel functions
B. Verify which EPROM is in the DAC-2
C. Preview Monitor Connections
D. Initial Software configuration
A. Explanation of front panel functions
Button Functions
DV Input
Select/Reset
The DV Button, has two functions:
It selects DV as the input source and is also a reset.
Resetting the DAC-2 will put it into its default setting based on its Firmware version.
Composite
Video, S-
Video, Y.U.V.
This button is for analog input source selection: Composite video (RCA), S-Video
(Y/C), and Y.U.V. (Component)
12/16 bit
Audio/Mode
Selection
The A Encode button has two important functions; it selects the encoding audio
frequency between 12 bit (32 KHz) or 16 bit (48 KHz) and if it is held down for 3
seconds it switches modes.
B. Verify which EPROM is in the DAC-2.
On the underside of the DAC-2 there is a serial number sticker, which has a version number on it, the version
number is stamped or on a sticker.
Please find your version number in the table below:

Datavideo DAC-2 Specifications

Inputs

S-VHS sources Y/C in	4—pin 75 ohm DIN connector
Composite input	1.0Vp-p 75 ohm RCA connector
Component Y, R-Y, B-Y input	75 ohm BNC connector

Outputs

S-VHS Source Y/C out	4-pin 75 ohm DIN connector
Composite Video Source output	1.0 Vp-p 75 ohm RCA connector
Component Y, R-Y, B-Y output	75 ohm BNC connector

General

Power	DC 9V 10W AC Adapter
Ambient Temperature	32° - 131°F (0° - 55°C)
Dimensions	8.3”(W) × 8.3”(D) × 2.2”(H)