Need help?Do you have a question about the Datavideo DAC-100 and is the answer not in the manual?
Lists the essential components included with the DAC-100 for initial setup.
Details the various input ports available on the DAC-100 for connecting video and audio sources.
Explains the output ports on the DAC-100 for sending processed video and audio signals.
Highlights the primary features and technical capabilities of the DAC-100 converter.
Explains the purpose and location of each button, LED, and connector on the front panel of the DAC-100.
Identifies and describes the rear panel ports, including FireWire, DC input, and DIP switch settings.
Lists the sequential steps required to successfully configure the DAC-100 for Avid Xpress DV.
Inputs and Outputs| S-VHS sources Y/C in | 4-pin 75 ohm DIN connector |
|---|---|
| Composite input | 1.0Vp-p 75ohm RCA connector |
| C-Sync Composite Sync signal in for Gen-lock | Yes |
| DV (iLink) Source Data Transfer Rate | 25Mbps, PAL 4:2:0 / NTSC 4:1:1 |
| S-VHS Source Y/C out | 4-pin 75ohm DIN connector |
| Composite Video Source | 1.0 Vp-p 75ohm RCA connector |
Audio and Video| Frequency Response | 4.5 MHz +/- 3 dB (DV input) |
|---|---|
| DG, DP | +/- 3%, 3° |
| Audio Sampling Rate | 12bit 32KHz and 16bit 48KHz option |
Power and Environment| Power | DC 5V / 6.0W AC Adapter |
|---|---|
| Ambient Temperature | 32° - 131°F (0° - 55°C) |
| Ambient Humidity | Less than 90 % |
Weight and Dimensions| Width | 6.15 inches |
|---|---|
| Depth | 6.0 inches |
| Height | 1.6 inches |
To Next Page
