12
SPECAL FUNCTION I
You can choose:
FRAME RATIO 80 / 90 / 0FF
4:3 MARK LINE ON / OFF
CENTRAL MARK ON / OFF
CINEMA ZONE
MARK
ON / OFF
MARK TYPE OVERLAY / TRANSPARENT
EXIT
SPECAL FUNCTION II
You can choose:
TIMECODE SETUP(VALID FOR SDI ONLY)
TITLE EDIT TITLE DISPLAY ON / OFF
TITLE POSITION MID-TOP / MID-BOT
FONT SIZE SMALL / LARGE
FONT COLOR RED / GREEN / ORANGE / WHITE
EDIT TITLE A~Z
EXIT
SETUP NETWORK
You can choose:
DHCP ON / OFF User choice
IP 127.127.127.127. User defined
Or set by DHCP if DHCP=ON
MASK 255.255.255.255. User defined
Or set by DHCP if DHCP=ON
GATEWAY 127.127.127.127 User defined
Or set by DHCP if DHCP=ON
MAC xx.xx.xx.xx.xx.xx unique to monitor
cannot be changed
EXIT
See Remote Setup sections for more details.
UPDATE F.W.
You can choose:
UPDATE SCALER F.W.
SCALER VER:
UPDATE FPGA F.W.
FPGA VER:
EXIT
See Firmware Update Procedure section for more details.
FACTORY RESET
Push ENTER button to reset the TLM-170P to restore the factory settings or default settings.
AUDIO CONTROL
You can choose:
INTERNAL AUDIO ON / MUTE / MUTE CTROL
EXTERNAL AUDIO ON / MUTE / MUTE CTROL
AUDIO INDICATOR* ON / OFF
AUDIO CHANNEL L 1
AUDIO CHANNEL R 2
EXIT
*dBFS audio peak meter shown as overlay in bottom left hand corner of display when this option is ON.
This display shows 8 channels of audio with SDI sources and 2 channels with other sources.
To Next Page
Loading...
Need help?
General
