Fiscal Printer DATECS FP-2000 Version 3.10
The number of free fields in the fiscal memory, reserved for saving information from the daily report.
45H (69) DAILY FINANCIAL REPORT
Data field: [<Option>[N][A]]
Response: Response: Closure,Total,TotA,TotB,TotC,TotD,TotE,TotF,TotG,TotH,TotI
Option A non-mandatory parameter controlling the type of generated report.
‘0’ A Z-report (Daily report with writing to fiscal memory and clearing the daily registers).
‘2’ A X-report (Daily report without writing to fiscal memory and clearing the daily
registers)..
N The presence of this symbol at the end of the data cancels the option to clear the data accumulated
on the operators during a Z-report.
A The presence of this symbol at the end of the data cancels the option to clear the data about sold
article quantities during a Z-report.
Closure Fiscal closure (Daily report) number – 4 bytes.
Total Total
TotX VAT group total (12 bytes with sign each field).
46H (70) INTERNAL DEBITING AND CREDITING (SERVICE IN AND OUT)
Data field: [<Amount>]
Response: ExitCode,CashSum,ServIn,ServOut
Amount The sum, which will be registered (up to 9 bytes). Depending on the sign of the digit, this sum is
interpreted either as credit or debit (serveIn or serveOut).
ExitCode One byte:
‘P’ The order has been completed. If the ordered sum is not 0, the printer will print an
interior receipt for registering the operation.
‘F’ The order has been canceled. This happens if:
- The cash sum available is less than the ordered interior credit (serveIn),
- There is an opened fiscal and non-fiscal receipt.
CashSum Available cash. Apart from this command, the sum grows after each payment in cash.
ServIn The sum from all commands “Interior credit”
ServOut The sum from all commands “Interior debit”
Changes the content of the cash availability register. Depending on the sign of the sum in question, it is
accumulated in the register for interior debit-credit. The information is not saved in the fiscal memory of device and is
accessible until the performance of the daily closure. It is printed out at the command 69 (45h) and at the generation of
the daily report without closure from the printer itself. At successful completion of this command, the drawer “kick-
out” function is automatically activated.
47H (71) PRINTING DIAGNOSTIC INFORMATION
Data field: None
Response: None
The command initiates the generation of an interior receipt containing diagnostic information as follows:
- Prints the date and version of the employed software,
- Prints the control sum of the employed firmware,
- Prints the serial port’s band rate,
- Prints out the status of memory switches,
- Prints emergency time after power supply cut-off,
- Prints the number, date and hour of the last reset of the RAM (if there is such),
- Prints the current temperature of the two printer heads,
- Prints the overall number of fields in the fiscal memory and the number of the free fields,
- Prints the current date and hour.
The command will not be executed when there is an open receipt in progress or when the paper roll has finished. It
may also be activated by pressing the <FEED> button while power on for less than 2 seconds.
48H (72) FISCALIZATION
Data field: <Serial>
To Next Page
Loading...
