Datecs DPP-350 - User Manual

Questions and Answers

J
Jennifer PughJul 27, 2025
What to do if Datecs DPP-350 stops responding?
- D
  Darlene HillJul 28, 2025
  If your Datecs Printer stops responding to print and paper feed commands, try removing the battery for 5 seconds and then reconnecting it.
M
Michelle JonesAug 2, 2025
Why is the Datecs Printer online LED blinking red?
- C
  Christopher AtkinsonAug 2, 2025
  If the On-line LED on your Datecs Printer is blinking red continuously, it could be due to a low battery voltage or the printer being out of paper, or paper not properly loaded. Consult the section on 'Loading Paper' for instructions.
K
kristinamcguireAug 8, 2025
How to fix Datecs DPP-350 Printer when paper feeds but no text prints?
- K
  karencollinsAug 8, 2025
  If your Datecs Printer is feeding paper after a print job but no text is visible, it may be because the thermal paper is loaded incorrectly with the special coating on the outside. Remove the paper roll and reload it properly. Alternatively, the paper cover might not be installed correctly, so ensure it is properly installed.
J
Jerome DominguezAug 14, 2025
What to do if Datecs DPP-350 prints light on half the width?
- E
  Edward SchultzAug 14, 2025
  If the printing on your Datecs Printer is light or missing on only half of the print width, it could be due to the paper cover not being properly installed. Consult the section on loading paper. It may also be caused by a mechanism jarred loose.
Q
qgreeneAug 21, 2025
Why does my Datecs DPP-350 print strange characters?
- S
  saranelsonAug 21, 2025
  If your Datecs Printer is printing strange characters, this could be due to low battery voltage. See the section on charging the battery pack.