Fiscal Printer DATECS FP-2000 Version 3.10
Data field: <Start>,<End>
or
<Period>
Response: None
Start Starting date - 6 bytes (DDMMYY)
End End date - 6 bytes (DDMMYY)
Period Used to print monthly or annual periodical report.
For monthly report – 4 bytes expected with format MMYY
For annual report – 2 bytes expected with format YY.
This command prints out a short financial report on the period between two selected dates or on the selected month
or year.
50H (80) SOUND SIGNAL
Data field: [<SoundData>]
Response: None
This command is used for making (beeping) a sequence of sounds with a certain frequency and duration. The data
is in format, similar to the one used for writing notes and can be of any length up to 218 bytes. The first invalid
character cancels the command. If the input string is empty, the one sound signal with frequency 2 kHz and duration
300 ms is emitted. SoundData format is a sequence of the following subcommands:
• Notes of the scale: One latine letter with value from ‘A’ to ‘G’.
‘C’ - Do
‘D’ - Re
‘E’ - Mi
‘F’ - Fa
‘G’ - Sol
‘A’ - La
‘B’ – Si
If immediately after the note comes character ‘#’, then the note is higher in pitch by a semitone (sharp). If
immediately after the note comes character ‘&’, then the note is lower in pitch by a semitone (flat).
• Pause: Character space (ASCII 20h).
After a note or pause there can be one or a few bytes, which specify the duration. Valid are characters from
‘0’ to ‘5’, they have the following meaning:
‘0’ basic duration of a note/pause
‘1’ basic duration * 2
‘2’ basic duration * 4
‘3’ basic duration * 8
‘4’ basic duration * 16
‘5’ basic duration * 32
If there are a few durations one after another they are summed up.
• Going to higher scale: character ‘+’.
• Going to lower scale: character ‘-‘.
• Specifying tempo: character ‘^’, followed by a number. The number specifies the percentage: duration of
notes and intervals to basic duration. Values:
‘1’ 200 %
‘2’ 175 %
‘3’ 140 %
‘4’ 120 %
‘5’ 100 %
‘6’ 80 %
‘7’ 60 %
‘8’ 50 %
‘9’ 40 %
• Return to scale 1 (it is default). Character ‘@’. Tone ‘La’ in it is 440 Hz.
53H (83) SETTING THE MULTIPLIER, DECIMALS AND ENABLED TAXES
Data fields: [Multiplier,Decimals,Enabled,TaxB,TaxC,TaxD,TaxE,TaxF,TaxG,TaxH,TaxI]
Response: Multiplier,Decimals,Enabled,TaxB,TaxC,TaxD,TaxE,TaxF,TaxG,TaxH,TaxI
To Next Page
Loading...
