Fiscal Printer DATECS FP-2000 Version 3.10
Record Start number of the fiscal memory record.
Type The type of the information demanded.
Record1 Optional end number of fiscal memory record for Type ‘1’, ‘2’ and ‘3’. For all other
subcommands this field is empty.
ErrorCode One byte with a value of:
• ’P’ Valid data found
• ‘F’ Wrong control sum (Data is invalid)
• ‘E’ The selected entry is empty
Data Returned data.
Type
Data format
“0” DecRecord,Decimals,Enabled,RateA,RateB,RateC,RateD,DateTime
“1” ClosCnt,RecCnt,TotA,TotB,TotC,TotD,TotE,TotF,TotG,TotH,TotI
“2” ClosCnt,RecCnt,NetA,NetB,NotC,NetD,NetE,NetF,NetG,NetH,NetI
“3” ClosCnt,RecCnt,TaxA,TaxB,TaxC,TaxD,TaxE,TaxF,TaxG,TaxH,TaxI
“4” Closure,DecRecord,ResetRecord,DateTime
“5” Decimals,Enabled,RateB,RateC,RateD,RateE,RateF,RateG,RateH,RateI,DateTime
“6” DateTime
Closure Z-report record number
DecRecord Fiscal memory decimals record number.
Decimals Decimals
Enabled Enabled taxes mask
RateX VAT rate (in %)
DateTime Date and time in format DD-MM-YY hh:mm:ss
ClosCnt Closure count for the period
RecCnt Fiscal receipt count for the period
TotX Accumulated turnover sum for the period
TotExcX Accumulated turnover sum from exchanges for the period
NetX Accumulated net sum for the period
NetExcX Accumulated net sum from exchanges for the period
TaxX Accumulated VAT sum for the period
TaxExcX Accumulated VAT sum from exchanges for the period
The command returns information on the different tax groups for each separate entry or a selected period of time.
Periodic references for longer time periods may take a few seconds to process.
Depending on Type, different information is returned:
“0” Information on the active decimals and VAT rates record for the Z-report with number Record
“1” Information on the accumulated turnover sums
“2” Information on the accumulated net sums
“3” Information on the accumulated VAT sums
“4” Information on the active decimals and VAT rates record for the Z-report with number Record
“5” Information on the decimals and VAT rates record with number Record
“6” Information on reset record with number Record
73H (115) PROGRAMMING A GRAPHIC LOGO
Data field: <RowNum>,<Data>
or R<RowNum>
Response: None
or <Data>
R If the letter is present at the beginning of the command, then the command returns the data of the
corresponding line.
RowNum Shows the line, which is being programmed - a number between 0 and 95
Data Graphic data. Two symbols for each byte of information are entered in the hexadecimal code
(Two symbols for every byte). The length of the data is up to 54 bytes, and if they are less, an
automatic addition of “00” follows.
This command offers the option to define a graphic logo with dimensions 72 x 12 mm (432 x 96 dots) designed by
the user themselves. The printing of this logo is activated with command 43. It is printed out immediately before the
To Next Page
Loading...
