3: Operation
3-18 RT7000-MSOP
2. Press F and 8.572 and E.
Display: CH FREQ
041 8.572000 MHz
Rx
Entering
Semi-duplex
Frequencies
The following steps explain how to select the channel and assign a new
frequency:
1. Press C and enter the 3-digit channel number.
2. Press E and F.
Display: xx. xxx, xxx
Rx
3. Enter the receive frequency.
4. Press F again.
Display: xx. xxx, xxx
Tx
5. Enter the transmit frequency and press E. The new channel frequency is
displayed.
6. Press F to toggle between the receive and transmit frequencies.
Example: To enter an RX frequency of 21.2 MHz and a TX frequency of 29.3
MHz on channel 41:
1. Press C and 41 and E.
Display: CH FREQ
041 xx.xxx,xxx
(where xx.xxx,xxx is the existing channel frequency)
2. Press F and 21.2.
Display: 041 21.200000
Rx
3. Press F and 29.3 and E.
Display: 041 29.300000
Tx
Note: If you enter any number after pressing F, the existing frequency
changes.
Assigning RX
Only Channels
To automatically limit a channel to a receive-only operation, enter ALPHA 8.
To convert the channel back to a standard RX/TX channel, enter ALPHA 18.
To Next Page
Loading...
