Installation and
Operating Instructions
for STERIFLO
®
Ultra Violet
Water Treatment System
Models SF1000S mkII & SF2500S mkII
Please pass these instructions onto the operator
of this equipment.
Distributed in Australia by Davey Water Products Pty Ltd.
DO NOT DISASSEMBLE ANY COMPONENTS UNTIL YOU HAVE FULLY READ
THESE INSTRUCTIONS!
Ultra violet radiation is harmful to skin & eyes.
DO NOT LOOK AT UV LAMP WHILE LAMP IS OPERATING.
WARNING: The UV Chamber operates under pressure. Under no
circumstances should the UV Chamber be disassembled unless the internal
pressure of the unit has been relieved. Failure to observe this warning will
expose persons to the possibility of personal injury and may result in
damage to the UV system or other property.
This unit is designed to treat water at ambient temperatures (5
o
C to 45
o
C).
Contact your dealer for details of UV systems suitable for hot water service.
Maximum operating pressure for stainless steel UV chambers is 850kPa (125
psi). If this pressure can be exceeded or if operating close to this pressure
fit a suitable pressure limiting valve in the supply to the UV chamber.
Plastic UV chambers have a maximum operating pressure of 400kPa (60 psi).
To Next Page
Need help?
General
