DAVID D2000 - Assembling the Vacuum

5
Attaching the Handle
to the Vacuum
NOTE: Do not plug in the vacuum until it
is completely assembled.
The vacuum cleaner and the handle are
packed separately and require assembly.
• Thread the cord through the lower and
upper cord guides on the back of the
vacuum bag (Fig. 1).
• Remove the handle bracket by
removing the two screws (Fig. 2).
• Place handle onto the back of the
vacuum, aligning holes with pegs
(Fig.3).
• Place the handle bracket back into
position (Fig. 4).
• Secure with two screws removed in
Step 2.
• Open the bag compartment to ensure
a vacuum bag is in place.
• Your vacuum is now ready for use.
• If storing the vacuum, wrap the cord
clockwise around the top and bottom
cord hooks. Fasten the plug to the
wrapped cord using the channel on
theplug.
Unwinding the Power Cord
• The lower cord hook rotates to allow
for quick access to the power cord.
Turn the lower cord hook upward and
you can quickly drop the power cord to
the floor without unwinding it from the
cord hooks.
• When storing the vacuum cleaner, turn
the lower cord hook to the downward
position and wind the power cord
around the cord storage hooks.
Fig. 2
Fig. 3 Fig. 4
Fig. 1
ASSEMBLING THE VACUUM