Daymak Boomerbuggy X Pro - HANDLE BAR CONTROLS

19
handle bar Controls
Above you will see the main handlebars. These are used to steer your vehicle. By pulling
the le side of the handlebar towards you will turn the vehicle to the le and vice versa.
On the handlebars there are some controls. Below is what each does:
1) Throle (Right Hand) - Pull this lever towards you to engage the motor and start
moving the machine forward. Push this lever away from you to move in reverse.
2) Speed Seng - Choose 1 of 3 sengs low medium and High. Low will give you the
most range while high will get you the top speed. (This is to be used in conjucon with
the potenometer dial. See Next Page)
3) Headlight - When it the right most posion all lights will be o. In the middle posion
the rear and accent LED lights will be on. And when in the le-most posion all lights will
be on.
4) Windshield Fluid - Press this to squirt windshield uid. See Page XXXX for lling the
windshield uid resevoir.
5) Horn - Press this to honk the horn.
6) Turn signal indicator - Press this to the le to indicate turning to the le and vice versa.
Once completed turning press this to the center posion to turn it o.
7) High Beam / Low Beam - Press this to angle the headlights up or down.
8) Throle (Le Hand) - Push this lever towards you to engage the motor and start moving
the machine forward. Pull this lever away from you to move in reverse.
Note: The BBX Pro can be driven with either hand, so use the instrucons based on
whichever you nd most comfortable.