Days Strider MD 3 - Adjusting the Seat Height - Positioning and Securing

21
Issued: 24.02.2005
STRIDER MD
The seat height (h) is adjusted using the
four holes (B1 - B4) in the seat support.
Pull the seat support (6) out as far as
the required height until the correct
hole (B1-B4) appears in the seat tube
hole (7).
Push the clamping bolts (3) with the
form shim (5) into the seat tube from
the front.
➨
➨
Adjusting the seat
support
tighten the clamping
bolt
Screw the self-locking nut (4) and tighten
it (size 12 mm). While doing this, prevent
the clamping bolt (3) from turning using a
second ring spanner (size 12 mm).
➨
Adjusting the seat height