Raider Mini 90 (single/double-seat): Service Manual Version：2.0 Feb. 2006
40
d) Push the container down strongly enough to break
the silver seals;
e) As electrolyte starts flowing into battery, air bubbles will come up from the mouths
of the plastic electrolyte bottles;
f) Leave bottles upside down in battery holes until electrolyte is completely drained;
NOTE: Never leave children unattended around battery.
g) If air bubbles cease to float to the top of the electrolyte bottles, tap lightly on top;
NOTE: DO NOT remove container from battery while it is draining.
. Never cut or pierce electrolyte container.
h) After all the electrolyte has drained from the bottles into the battery, pull plastic
electrolyte bottles gently out of the battery;
i) Discard empty electrolyte bottles in a waste area that is inaccessible to children and
animals;
j) After filling, let battery stand for at least 30 minutes before charging (This allows
the electrolyte to penetrate plates for optimum performance and ensures longer
battery life);
k) After 30 minutes the battery is ready for its initial
charge, place cap strip loosely over the filling holes
as shown in the picture.
z Initial Charge
a) Connect the red positive (+) cable to the red
positive (+) pole of the battery;
To Next Page
Loading...
