Need help?Do you have a question about the dbx 902 and is the answer not in the manual?
General| Brand | dbx |
|---|---|
| Model | 902 |
| Category | Computer Hardware |
| Language | English |
Connect signal leads to A+ and A- terminals or pin 3 (hot) and pin 2 (cold) of XLR for F900A mainframe and FS900 miniframe respectively.
Wire hot lead to A+ and shield to A- for mainframe, or pin 3 and pin 2 of XLR for miniframe; check phase if hum occurs.
Sets the crossover frequency (800 Hz to 8 kHz) for separating high/low frequencies for de-essing sibilants.
Sets the amount of de-essing effect. Normal region is for vocals; beyond that is for special effects or instrumental material.
To Next Page
