Need help?Do you have a question about the dbx Zone Pro 640 and is the answer not in the manual?
General| Input Channels | 6 |
|---|---|
| Output Channels | 4 |
| Type | Digital Signal Processor |
| Network Connectivity | Ethernet |
| Power Supply | 100-240V AC |
| Signal to Noise Ratio | > 100 dB |
| Maximum Input Level | +20 dBu |
| Maximum Output Level | +20 dBu |
| Power Supply Frequency | 50/60 Hz |
| Control Interface | Ethernet, RS-232 |
| Frequency Response | 20Hz - 20kHz |
| Input Impedance | 10 kΩ |
| Output Impedance | 100 Ω |
| Dimensions | 19" x 1.75" x 8.5" |
Details electrical hazards, user serviceability, water, ventilation, and heat precautions.
Explains mains lead wiring, earthing, UK plug warnings, and fuse replacement.
Discusses EMC compliance and the Declaration of Conformity.
Details the connectors and ports on the rear of the ZonePro unit.
Details the steps for configuring inputs, outputs, and zones.
Details input level, EQ, AGC, and notch filters.
Explains compressor, noise gate, de-esser, and feedback suppression.
Details routing, ducking, Auto Warmth, and filters.
Covers output EQ, dynamics, limiter, and delay settings.
To Next Page
