12
Turn off the vacuum cleaner.
Disconnect the extension tube and a turbo brush.
Press the button (1) to disconnect dust collector from the vacuum cleaner.
Click on the cover lock of dust collector. Open it and remove the debris.
Turn the lid of the filters and align the color label on the lid marked «Open»
on the housing of the dust collector.
Open the dust collector and remove all filters.
Rinse the filters and the housing of the dust collector under running water.
When the body of the dust collector and the filter has fully dried, assemble
the dust collector.
Install the lid of the filter housing of the dust collector and turn it until it stops
by aligning the color label on it labeled «Lock» on the body of the dust col-
lector.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Removing the turbo brush, you can use the furniture nozzle or a combination
nozzle. If necessary, you can use the turbo brush without extension tube.
OPERATION OF THE DEVICE
1. The battery should be fully charged.
2. To activate the vacuum cleaner, press and hold for 1 second the on/off button
3. If you want to increase the suction power, press the power button (2) again.
4. After cleaning, press the button (2) to turn off the vacuum cleaner.
Cleaning area light allows to clean half-light places under tables, beds and
sofas better.
CLEANING AND MAINTENANCE
Control the filling of the dust collector. As soon as the amount of debris in the
container reaches the «Max» mark is required to clean the dust collector.
To Next Page
Loading...