Dea TEO 700 - Electrical Connections and Wiring

11
5 ELECTRICAL CONNECTIONS
Execute the wiring following the directions of the diagrams.
WARNING To ensure an appropriate level of electrical safety always keep the 230V power supply cables apart (minimum 4mm in the
open or 1 mm through insulation) from low voltage cables (motors power supply, controls, electric locks, aerial and auxiliary circuits
power supply), and fasten the latter with appropriate clamps near the terminal boards.
WARNING Connect to the power supply 230 V ~± 10% 50 Hz through a multi pole switch or a different device that can ensure multi pole
disconnection from the power supply, with a contact opening of 3 mm.
WARNING To connect the encoder to the control panel, use only a dedicated cable 3x0,22mm
2
.
Wiring Diagram
START
FLASH 24V
PE
PB
Flash
+24V
GND
AC/24V
ROSSO
RED
ROUGE
ROT
ROJO
VERMELHO
CZERWONY
КРАСНЫЙ
NERO
BLACK
NOIRE
SCHWARZ
NEGRO
PRETO
CZARNY
ЧЁРНЫЙ
MOTOR
uscita lampeggiante intermittente
intermittent flashing light output
sortie clignotant intermittente
Ausgang blinkend für Blinklampe
salida destellante intermitente
saída de luz intermitente
wyjście lampy ostrzegawczej świecenie przerywane
выход прерывистого проблескового фонаря
TX
RX
COM
N.C.
N.O.
PHOTO 1