Dea TEO 700 - System Programming and Configuration; Power Supply and Initial Setup; Motor Stroke Learning Procedure; Transmitter Management

12
6 PROGRAMMING
1 Power Supply
Turn on the power supply, the courtesy light ashes for a few seconds and the display shows numbers “ ” to “ ” followed by the standby
symbol “- -”.
8
8
-
7
7
-
6
6
-
5
5
-
4
4
-
3
3
-
2
2
2 Motor stroke learning
1. Press on the key until the display shows
P1;
2. Conrm by pressing the key;
3. When “ ” is shown, press the keys /
so the door opens (“ ” ashes);
Conrm the opening position by pressing the
key;
4. When “ ”, appears, press the keys /
so the door closes (“ ” ashes);
Conrm the closing position by pressing the
key;
5. The door automatically opens and closes loo-
king for the opening/closing positions;
6. The display will show “- -“, programming com-
plete.
3 Deletion of memorized transmitters
1. Press and hold the key (display shows “ ”) for 8 sec. until
you see “ ” on the display;
All remotes previously memorized will be deleted;
Warning: After 20 memorized codes (upper limit), the display shows
“
”.
4 Transmitters learning
1. Press and hold the key until the display shows “ ”;
2. Press the remote key you want to learn, then release it and press
a second time (the display shows “ ” ashing);
3. The display will show “- -”, learning complete;
4. Repeat this procedure to learn other remotes up to a maximum
of 20 codes;
Warning: After 20 memorized codes (upper limit), the display shows
“
”.