12
2.4 Deleting user codes
• Access the device’s programming mode. The indicator light will begin ashing;
• Enter the number of the position to be deleted from 01 to 40. The device will emit 2 beeps;
• Press the button to delete the code saved in that position. The device will emit 3 beeps to con-
rm the operation;
• Go back to point 2 to delete additional user codes, or else press the button to exit from pro-
gramming mode (the device will emit 5 beeps).
2.5 Deleting a user code with an unknown position
• Access the device’s programming mode. The indicator light will begin ashing;
• Press the button. The device will emit 2 beeps;
• Enter the 4 digit access code to be searched for and deleted. The device will emit 3 beeps to con-
rm the operation;
• Go back to point 2 to search and delete additional user codes, or else press the button to exit
from programming mode (the device will emit 5 beeps).
2.6 Deleting all the parameters
Warning: This operation deletes all the parameters and user codes that have been set, with the ex-
ception of the master code.
• Access the device’s programming mode. The indicator light will begin ashing;
• Press the
button once. The device will emit 2 beeps;
• Press the button again. The device will emit 2 beeps;
• Press the button again 7 times to delete all the data;
The indicator light will turn off and the device will emit 5 beeps to indicate that the deletion pro-
cess has been completed.
2.7 Adjusting the timing of the electric lock
Warning: The timing is set to 5 sec. by default.
• Access the device’s programming mode. The indicator light will begin ashing;
• Enter 00 (to select position 00);
• Enter 2 digits (from 01 to 99 seconds) for the desired relay locking time;
• At this point the timing has been saved and the intercom will return to programming mode (the
device will emit 3 beeps);
• Press the
button to exit from programming mode (the device will emit 5 beeps).
To Next Page
Loading...