Deagostini Robi - Fitting Robis Eyes to Head Frame

17
18
FITTING ROBI’S EYES
Holdin the parts toether, insert and tihten two of the M2 x
4.5mm countersunk screws.
19
20
Repeat Steps 15-18 to attach the left eye. You may find this
easier if you turn the head frame assembly upside down as
shown.
Your assembly should look like this. Check
that the wider part of the whites of Robi’s
eyes are towards the outside of his head.
Insert the eye behind the head frame, and
alin the holes so that they are ready to be
screwed toether.
15 16
Pick up either of the completed eye
assemblies. The first one you fit will
become Robi’s riht eye.
Hold the head framework from Step 8 as shown, turnin the eye
around until the circled holes in the eye frame line up with those on
the riht of the head frame.
09