DECATHLON (D & HD) SERIES GAS FRYERS
CHAPTER 6: INSTALLATION AND OPERATION
6-9
6.3.2 Filtering Tools
Assemble tools to be used for filtering. These are supplied with the filter starter kit included with
the fryer/filter system:
Frypot/Filter Brush - used to clean frypot and filter pan sides and bottom, heating elements,
and to dislodge sediment during filtration or oil change.
Clean-out Rod (design may vary) - used to dislodge heavy debris in the drain tube (when needed).
Filter Powder.
Filter Paper (not used in filter-leaf equipped filter systems).
The following tools are not required, but are recommended to make the filtering task easier.
Measuring Cup - used to measure filter powder.
Stainless Steel Crumb Scoop - for removing large debris from oil prior to filtering.
Note: Always wear oil-resistant, insulated gloves and/or protective gear when
working with hot oil.
To Next Page
Loading...
