decon JWB2 - Page 28

28
3
Charger lamp indication
Battery capacity
indicator lamps
Description
Charge lamp (green) is on
Charge lamp (green)
Turn on
succes-
sively
Indicates normal charging.
Thechargelampwillturno󰀨afterchargingis
completed.
Chargelamp(green)isashing
(once per second)
Charge lamp (green)
On
Flashing
Indicates charge standby.
• When the temperature of the battery is not within the charge-
able range 32 to 104°F (0 to 40°C), the charger enters a stand-
bystateandthechargelamp(green)startsashing.
• Once the battery temperature falls within the chargeable range
during standby, charging will start automatically and the charge
lamp(green)changesfromaashingtoan“on”state.How-
ever, if the charge standby condition continues for a long time,
chargingwillend,andthepowerforthechargerwillturno󰀨.
Chargelamp(green)isashing
(5 times per second)
Charge lamp (green)
Flashing
On
Indicates timeout of charge standby.
• The charger has remained in standby mode for a long time and
has stopped charging the battery. Re-locate the charger and try
to charge the battery again
Litorashingred
Charge lamp (red)
O󰀨
The charger has detected a problem in the charger
or the battery, and is unable to charge. Stop charging
by disconnecting the charger plug and the power
plug. Check the battery, charger, and cord connection
for any problem, and then try charging again.
Ifthechargelamplightcomesonorashesinred
again, an equipment failure may have occurred.
Stop charging by disconnecting the charger plug and
the power plug, and have the equipment inspected
by a dealer.
Refreshlamp(orange)isashing
Refresh lamp (orange)
Flashing
On
Refresh charging is being requested.
Whiletherefreshlampisashing,presstherefresh
switch to perform a refresh charge cycle.
If you do not press the refresh switch, a normal
charging begins after 1 minute.