09
③ Check "air filter"
Open the air inlet cover and check whether the
"air filter" is installed in place and clean.
Air inlet cover/air filter (internal)
④ Connect the power line
As shown in the Figure on the left, insert the output end of
the power line into the power socket of the oxygen machine,
and then insert the other end of the power line into the
socket.
⑤ Connect the oxygen inhalation tube
Insert the large-diameter end of the oxygen
inhalation tube into the "oxygen outlet" of the
host engine.
※ If there are too many water drops in the
water collector during or after oxygen
inhalation, please open the water collector
and pour out water.
outlet of the oxygen machine water tank, align it with the bottom clamping
slot, and install the humidification water tank back to its original position.
※It should not be higher than the highest water level. Water injection is
not necessary, and it is only for humidifying oxygen gas. You may not
inject water if you don't think the oxygen is dry.
Oxygen inhalation tube
To Next Page
Loading...
