PAGE 3
YOUR ET: This is where you enter you own vehicle’s dial-in. Use the
scroll arrows or cursor button to make changes. If you run a Remote Dis-
play dial-in board, this is the setting that will be displayed upon return to
run mode.
SETTING TRANSBRAKE DELAY
RUN SCREEN: This is the screen the
THUNDER
will display when it is
“ready to run”. It will always display YOUR ET and your DELAY. When in
Crossover, Interface and Cross Talk modes it will also display THEIR ET.
NOTE: If you are not using the remote display dial-in board (part#
RD-1) the YOUR ET setting is not important when in the DELAY
mode. This setting will not effect your delay time.
To set your transbrake delay, you must first choose which delay box type you wish to run by pressing the MODE
button. The
THUND ER
will only ask for the settings required for that particular mode. Example: When you are in
RUN (DELAY) it will not ask you for THEIR ET setting since you are not crossing over. All of the shared settings
between these modes will transfer when you change to a different mode. Example: Your delay setting will transfer
over to all four different delay box modes along with your SKIP, TB PAUSE, and TB LOCK OUT settings.
10.00 9.00 1.000
RUN (INTERFACE)
THEIR ET YOUR ET DELAY
SETUP MODE
YOUR ET 09.00
SETUP MODE
THEIR ET 10.00
THEIR ET: This is the next screen that will appear in Interface, Cross-
over and Cross Talk modes (not needed in Delay mode). Use the scroll
arrows or cursor button to change this setting to your opponent’s dial-in.
Press the TBRK button to enter the transbrake adjust settings menu. Each time you press this button it
will advance to the next set-up screen. Once you have advanced through all of the screens, the box re-
turns back to run mode. When you are through making adjustments to the settings, the box will automati-
cally return to the run mode in 8 seconds.
SETUP MODE
DELAY 1.000
DELAY: When you first press the TBRK button, the delay setting will ap-
pear. Use the scroll arrows or the cursor button to change this setting. For
leaving off the top bulb on a full tree, this setting is typically around 1.000
second.
SETUP MODE
DELAY 2 .500
DELAY 2: This screen will appear next only in Cross Talk mode (not
needed in Delay, Crossover or Interface). Delay 2 is the amount of delay
used for taking a 2nd hit at the 2nd amber bulb on a Cross Talk bracket
tree. Typical 2nd amber delay setting is around .500 second. Use the
scroll arrows or cursor button to change this setting.
SETUP MODE
BOT DELAY .100
BOT DELAY: Bottom bulb delay time is the amount of delay you need for
a bottom bulb release on a full tree when using the “Last Chance” feature
while in Interface and Cross Talk modes. Adjust with scroll or cursor but-
ton.
T
B
R
K
413 W. Elm Street, Sycamore, 60178 • (866) 248-6357 • www.autometer.com • service@autometer.com
To Next Page
Loading...