2.6.2 Customising the main screen display
You can configure the main screen of the display by adding two
information boxes on the screen, one to the left and one to the right of the
rotary dial.
The information boxes can show:
Time and date
Detailed information about your system
You can also change the display of the temperature to show the current or
target temperature.
For more information, see
Main screen setting, page 23
Display current or target temperature, page 23
2.7
Zone selection
In case you have multiple zones in your heating system, it is possible to
control temperatures in multiple zones. A zone can be a room or, for
example, the ground or first floor. The zones are named CircA, CircB etc.
by default. These factory names can be changed in any name you prefer.
You can change the names on the Smart TC° or in the app.
The multiple zoning options needs to be supported by a matching
appliance configuration.
For more information, see
Changing the name of a zone, page 25
Changing the zone temperatures, page 17
2.8 Presence detection
The main screen of the display will light up (for 5 seconds) if the presence
sensor detects that you are in front of the Smart TC° or pass by. You can
disable the presence sensor in the settings menu.
For more information, see
Presence sensor, page 23
Fig.18
2 Introduction
12 7720691 - v.01 - 05102018
To Next Page
Loading...
Need help?
General
