Dedoes Alliance - Ensure Alliance Machine is Square and Level

How to make you Alliance Machine square and level
During the inial installaon of your Alliance Machine it should have been placed on a level surface. Also,
the machine should have been made square and have the wall anchors installed to help retain the posion
of the machine.
Misalignment in the machine can lead to the shas not sing correctly, they will then begin to “wobble”, or
grind against the drive gears through out the machine. This leads to fricon, fricon causes heat, heat causes
expansion, and expansion causes damages and breakages. Misalignment in the machine is oen reflected in
the drive gear, the bushing, and the gear reducer.
We recommend that you check your machine for alignment every six to eight months of operaon.
We also suggest that aer compleng and repairs or part replacement on a machine that you check to
ensure alignment is correct as well.
The wall anchors that were supplied in the motor box of your machine are very important to help retain
alignment over me. They secure the top of the machine to the wall. This helps to prevent movement during
operaon. Wall anchors also provide a safety against the machine pping onto a user.
To adjust the alignment to your machine:
1 - Loosen the four thumb screws in the le and right feet.
2 - You can now push or pull the machine to the le or the right to guide it back to square.
3 - Re-ghten the four thumb screws.
4 - If need be ghten or reposion the wall anchors for more stability.
1
2
Wall Mount Brackets
4
Level Surface