Need help?Do you have a question about the DEEPELEC NanoVNA-F and is the answer not in the manual?
General| Measurement Types | S11, S21 |
|---|---|
| RF Connector | SMA Female |
| USB Interface | USB Type-C |
| Number of Scanning Points | 101 |
| Display Tracking | Yes |
| Marker | Yes |
| Saving Settings | Yes |
| Frequency Range | 50 kHz to 1.5 GHz |
| Display | 2.8 inch TFT LCD |
| Battery | Li-ion |
| Calibration | Open, Short, Load, Through |
| Power | USB or Battery |
| Number of Calibration Points | 101 |
| Port VSWR | ≤ 1.5 |
Step-by-step instructions for initiating a new measurement on the NanoVNA-F.
How to choose display formats, scales, and channels for measurement traces.
Methods for configuring the start, stop, and center frequencies for measurements.
Demonstrates different ways to set frequency ranges using center, span, and start/stop parameters.
A concise overview of the procedure for performing SOLT calibration on the NanoVNA-F.
Contact information and resources for technical support and user discussions.
Tips to identify genuine NanoVNA-F units and avoid counterfeit products.
Guidance for users who received a NanoVNA-F without an integrated battery.
Instructions on how to conduct the RF calibration procedure for accurate measurements.
Guidance on the frequency and conditions for recalibrating the NanoVNA-F.
Steps to follow for calibrating the touch screen interface of the NanoVNA-F.
Detailed instructions for downloading and installing new firmware versions.
Procedure to customize the device by adding a personal call sign.
Instructions for connecting to a PC and installing necessary drivers for the NanoVNA-F.
To Next Page
