Page 12
Important information for the installer
This appliance may only be installed by a
registered LPG Gas installer registered
with the Liquefied Petroleum Gas
Association of Southern Africa.
The appliance must be installed in
accordance with the requirements of
SANS 10087-1 or SANS 827 and any fire
department regulations and/or local
bylaws applicable to the area. If in doubt
check with the relevant authority before
undertaking the installation.
Upon completion of the installation you are
required to fully explain and demonstrate to
the user the operational details and safety
practices applicable to the appliance and the
installation including:
a) The position of the isolation or shut-off
valve in the gas supply line to the
appliance.
b) The requirements for safe operation of the
appliance
Note.This appliance is supplied ex-
factory with jets and air settings for use
with LPG gas only.
Safety compliance with local
requirements:
Installer’s details are to be filled in on
page 32 of this book
Temporary installation
Flexible hose connection from the gas
appliance to the cylinder can be made.
Ensure that pipe clamps are tightened
correctly and are of a good quality.
• Flexible hose - Not supplied.
Any hose that is used to connect the
stove to the gas system shall comply with
SANS 1156-2 or BS 3212.
• Gas cylinder - Not supplied.
For best results we recommend that gas
cylinders with a minimum capacity of 19kg
be used.
• Regulator - Not supplied.
A 2.8-3.0 kPa LPG gas regulator which
complies with SANS 1237 must be used.
Permanent installation
Important information for the user
This appliance may only be installed by a
registered LP Gas installer. All registered
installers are issued with a card carrying
their registration number.
Ask to be shown this card before
allowing the installation to commence
and make a note of the installer QCC
number on page 32 of this book.
Upon completion of the installation, the
installer is required to explain the operational
details of the appliance together with the
safety instructions. You will be asked to sign
acceptance of the installation and be
provided with a completion certificate. You
should only sign for acceptance when the
installation is completed to your satisfaction.
Failure to comply with the above will
render the warranty invalid.
Note:
Your invoice is required in the event of
you wishing to make a warranty claim.
To Next Page
Loading...
Need help?
General
