Page 9
Oven flame failure
safety cut out. (Oven
only) In the unlikely event
of a flame blow out,
caused by an overflow of
fluid at the oven burner, a
safety mechanism will
automatically shut off the
gas to the oven
approximately 30
seconds after the flame
extinguishes.
Electrical safety
If the appliance has a failure, it
should not be operated unless it
is repaired by an authorized
service agent. There is a risk of
an electric shock!
Connect the appliance to an
earthed outlet/line protected by
a fuse of suitable capacity.
Have the earth installation
made by a qualified electrician.
This appliance must be earthed
and the manufacturer and the
seller do not accept
responsibility for any damage
due to incorrect installation or
electrical connection.
The appliance must be
disconnected from the mains
during installation,
maintenance, cleaning and
repair procedures.
The appliance must be installed
so that it can be completely
disconnected from the network.
The separation must be
provided either by a mains plug,
or a switch built into the fixed
electrical installation according
to construction regulations.
If the supply cord is damaged, it
must be replaced by the
manufacturer, its service agent
or similarly qualified persons in
order to avoid a hazard.
The rear surface of the stove
gets hot when it is in use.
Ensure that the electrical
connection does not come into
contact with the rear surface so
as not to damage connections.
Do not trap the mains cable
between the oven door and
frame and do not route it over
hot surfaces as the cable
insulation may melt and cause
a fire as a result of a short
circuit.
Any work on electrical
equipment and systems should
only be carried out by
authorized and qualified
persons.
Never wash down the appliance
with water! There is the risk of
electric shock!
SAVE THESE INSTRUCTIONS
To Next Page
Loading...
