EasyManuals Logo

Defy DTD310 User Manual

Defy DTD310
14 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
Page 5
Insert the adaptor piece into the exhaust
outlet at the rear of the dryer, and screw
one end of the flexible exhaust tube into
the adaptor.
The other end of the exhaust tube may be
directed through an open window or
connected to a wall mounted vent.
The sketch above shows the preferred
direction the tube should follow.
The exhaust air may not be directed into
chimneys, flues or fireplaces
If required, a permanent exhaust pipe
may be installed and should be routed
with as few bends as possible so as not to
restrict the airflow.
The maximum length of such a pipe is
given below.
Electrical connection
The dryer must be plugged into a
dedicated 230V. 16A. earthed wall
socket.
Do not use a double adaptor.
The manufacturer and seller do not accept
responsibility for any damage due to
incorrect electrical connection.
If the power cord needs replacing, use
only a genuine type ‘X’ cord available from
the nearest Defy Service Centre. The
power cord must only be replaced by an
authorised service agent to avoid an
electrical hazard.
Installation
Ensuring the correct installation is the
customer’s responsibility.
Location
The dryer should be located in a well
ventilated room, away from heat sources
such as gas, oil or coal fired appliances.
Position the dryer on a flat, even,
uncarpeted floor.
The dryer vents to the outside and
utilises a dedicated air outlet hose for
this purpose. For this reason it is best to
position the dryer near an outside facing
wall or window.
Ensure that an electrical supply point is
within easy reach of the power cord.
Levelling
Level the dryer by turning the adjustable
feet either in or out.
Two rubber friction pads may be fitted
under the adjustable feet to help prevent
movement of the dryer on slippery
surfaces. If required, these may be
purchased from your nearest Defy
Service Centre. The friction pads are
easily clipped into the front adjustable
feet of the dryer.
Venting exhaust air to the outside
The dryer must be vented to the outside,
either by means of the flexible exhaust
tube supplied or via a permanent
installation.
2

Other manuals for Defy DTD310

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Defy DTD310 and is the answer not in the manual?

Defy DTD310 Specifications

General IconGeneral
BrandDefy
ModelDTD310
CategoryDryer
LanguageEnglish

Related product manuals