MAINTENANCE
Cleaning the Lint Filter
• The lint filter, which is located behind the door, should be cleaned after each load to
maintain optimum drying efficiency.
• Lift the filter out and remove all the lint by gently rubbing the filter mesh.
• To replace the filter, hold it above the slot in the door (with the arrow facing the
door) and gently lower it into position.
• Ensure that the filter is fully in position before closing the door.
Cleaning the rear Air Intake Grille
• The air intake grille should be cleaned regularly to maintain optimum drying
performance.
• Remove any obstructions and dust the grille off with a soft brush.
Cleaning the cabinet
• The surfaces of the Dryer need very little attention.
• Periodically wipe the inside of the drum and then the outer cabinet with a damp
cloth.
• An occasional polish of the outside panels with a good furniture wax will maintain a
shiny finish.
• Do not use wax or any household cleaner on the control panel timer knob.
SPECIFICATIONS
Drying capacity 5kg. Height 850mm.
Operating voltage 50 Hz-230V Width 559mm.
Heater 2 x 1000 W Depth 485mm.
Motor 94 W
Max. power 2094 W
Net weight 28kg.
To Next Page
Loading...
