Why won't my Degelman Tri-Plex Landroller 7634 Landroller rollers turn?
The Landroller rollers might not turn due to material build-up around them. If only one roller isn't turning, it could be a faulty bearing. Make sure there is no material build-up around the rollers.
What to do if the wings of my Degelman Tri-Plex Landroller 7634 Farm Equipment fall back when driving in the field position?
If the wings fall back when driving in the field position, it might be that the Landroller is not latching correctly when put into field position. Ensure the Landroller is on level ground when backing up to the latch mechanism, and that the swing-arms fully engage into the latches. The transport wheels must be fully up in order for the latches to fully engage. If the problem persists, adjust the eye bolt on the cable for the mechanism to latch tighter.
How to fix uneven ground contour and compaction on the center section of my Degelman Farm Equipment Landroller?
Uneven ground contour and more compaction on the center section of the Landroller may occur if the center hitch frame is not in the float position. Ensure that the Landroller front hitch frame float plate has been placed into the float position using the ratchet jack. The float plate gap should be raised to approximately 1-1/4”.
What causes excessive play or binding in the rockshaft area of Degelman Tri-Plex Landroller 7634?
Excessive play or excessive binding in the rockshaft area (center frame wheel assembly) might be caused by cast support blocks around the rockshaft not being correctly adjusted. Lower the rollers to the ground and lift the transport wheels off the ground. Check if the play in the rockshaft area is excessive. If so, remove the cap of the casting blocks around the rockshaft, and remove shims until the desired clearance is achieved to take the play out. Note: Do not remove too many shims, and make it too tight. If there is binding, ensure you have adequate grease in the block itself, and that it’s not rusted from a long time of storage in one position.
What to do if one wing of my Degelman Tri-Plex Landroller 7634 won’t open into field position?
If one wing won’t open up into field position, this could be due to uneven ground, a faulty relief, seized swing arm tubes, or possible binding in the cross joint area. Ensure you are on level ground. Try backing up a slight slope to help assist the wings to fold out. Unhook the swing arm tube and move manually to ensure that the swing arm is not seized. If the problem persists, contact your local Degelman dealer.
General| Brand | Degelman |
|---|---|
| Model | Tri-Plex Landroller 7634 |
| Category | Farm Equipment |
| Language | English |
To Next Page
