EasyManua.ls Logo

DEI 600HF - VRS Triggering Sequence

Default Icon
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
© 1990, 1996 Directed Electronics, Inc.
NOTE: If the VRS is armed while operating the vehicle and not disarmed prior to leaving the vehicle,
it remains armed and will trigger the next time the vehicle is driven.
VRS Trigger Sequence
Fifteen seconds after the last door has closed, the system's
Status LED will begin flashing. This delay is to allow you to put
distance between yourself and your vehicle in the event of a
carjacking.
NOTE: If the system is in Valet Mode, the VRS feature will still protect your vehicle. However, the
Status LED will not provide this first-level indication if the VRS triggers with the system in Valet
Mode.Forty-five seconds later, the Soft Chirp Revenger™ Siren will begin chirping and the parking
lights will begin flashing. This time could be used to notify authorities that your vehicle has been hi-
jacked, and tell them what the VRS will do next.
Fifteen seconds after the siren chirps begin, the siren's out-
put will change to a continuous blast.
From this point on, when the ignition key is turned off, the
VRS will immediately turn on the FailSafe Starter Kill. This
will prevent the vehicle from being restarted, thus immobi-
lizing it at that spot.
Three minutes after the constant siren output begins, the
flashing parking lights and the siren will stop.The starter kill
will remain active until the VRS system is disarmed. If the
door is opened or the ignition is turned off and on in an at-
tempt to restart the car, the siren and flashing lights will
begin again.

Related product manuals