6
© 1990, 1996 Directed Electronics, Inc.
Valet
®
Mode
You can prevent your system from automatically arming and triggering by
using Valet Mode. This is very useful when washing the vehicle or having it
serviced.In Valet Mode, the system will not arm, even with the transmitter, but
all convenience functions (door locks, trunk release, etc.) will work normally.
You can access Valet mode either manually or from the remote transmitter.
To enter or exit Valet
®
Mode with the Valet switch:
Turn ignition to the "run" position, then turn to the "off" position. Press and re-
lease the Valet switch within 10 seconds. The Status LED will shine steadily
if you have entered Valet Mode, and it will go out if you exited Valet Mode.
Using Remote Valet
®
as you enter or exit the vehicle:
Open any door.
Press Button I, Press Button II, Press Button I again.
The Status LED will shine steadily if you entered Valet Mode, and it will go
out if you exited Valet Mode.
Nuisance Prevention Circuitry
TM
Your system includes Nuisance Prevention Circuitry (NPC™). This feature
prevents annoying repetitive trigger sequences due to faulty door pin switch-
es or environmental conditions such as thunder, jackhammers, airport noise,
etc. Here's how it works:
1
2
1
To Next Page
Loading...