4.3 Mains power export
In this mode a constant level of power through the mains breaker is maintained. The power can be exported to the mains or
imported from the mains, but always at a constant level. The set point can be 0 kW for zero export applications.
Start sequence
1. Activate a start signal for the PV.
• AUTO mode:
◦ The PV breaker closes automatically when you select AUTO mode, and the voltage and frequency are OK.
◦ Activate a start signal with digital or time-dependent inputs.
• mode:
◦
Push the Close breaker
button to close the PV breaker.
◦ Push the Start button on the controller.
2. The PVS ramps up to reach the MPE kW set point (parameters 7001 and
3. If the PVS cannot supply this load, the mains supplies the remaining load.
Settings > Power set point > Mains power export and peak shaving > Day/night power set
point
Parameter
Text Range Default
7001 Mains power, Day to 20000 kW 750 kW
7002 Mains power, Night to 20000kW 1000 kW
7006 MPE/PS scale
OPERATOR'S MANUAL 4189341347A EN Page 16 of 32
To Next Page
Loading...