3. Operating the system
3.1 Mimic function
Settings > Basic settings > Controller settings > Display > LED mimic
Parameter no.
Item Range
6082 LED mimic
Standard
Guided
Standard
The control buttons and LEDs are shown.
If you the stop the photovoltaic system the PVS symbols are
shown in red.
Guided
Active control buttons, LEDs, and the PVS symbols are shown,
inactive are not shown.
Example: The controller is in mode, and the PVS is not
operating. The only possible action is to start the PVS, or open the
mains breaker. Therefore, only the start button, the red PVS
symbols, and the button to open the mains breaker are shown.
All Mimic settings
The breaker symbol is shown in red:
• Breaker position failure
• Breaker close failure
The breaker symbol flashes green:
• The controller is synchronising
• The controller is de-loading
3.2 Running modes
The controller has two running modes:
• AUTO : The controller operates automatically and the operator cannot start sequences manually.
• SEMI-AUTO : The operator must start all sequences. You can do this with the buttons, Modbus commands, or digital
inputs.
SEMI-AUTO mode
Use external signals to operate the controller in mode.
Give an external signal with:
1. Buttons on the display
2. Digital inputs*
OPERATOR'S MANUAL 4189341347A EN
Page 9 of 32
To Next Page
Loading...