dejavoo Z11 Initial Setup

Dejavoo Z11
Initial Setup of the Dejavoo Z11
 Plug the power cable into the outlet and power on the device.
 Connect the device to your network via Ethernet/WiFi.
 Press the green “OK” button and type in the default password “1234”
 Press “Utility” and type in the default password again.
 Press “Communications” then “Print Details”.
 Click “Local Parameters” then “Wi*” or “Ethernet”, whichever you're
connected to.
 This report will tell you your IP address. Keep this handy as we will
need it later.
Page 1 of 3

dejavoo Z11 Specifications

General

Processor	32-bit ARM11
Operating System	Linux-based
Memory	128MB Flash, 64MB SDRAM
Connectivity	Ethernet
Card Readers	EMV, NFC, Magnetic Stripe
Printer	Thermal printer, 18 lines/second
Battery	Optional
Certifications	EMV L1 & L2