36BB, 36BDB
BRUSH BEAST
15
Rev: Mar2011
BRUSH BEAST Brush Mower
Item Procedure
Time Interval
Break-in
(first 5 hrs)
Every 8 hrs
(daily)
Every 40 hrs
(weekly)
Every 100 hrs
(Bi-weekly)
Every 200 hrs
(monthly)
Belts
Inspect (adjust if
needed)
X X
Blades Inspect and Sharpen
X
Engine Air Filter
Inspect (see Engine
Owner’s Manual)
X
Engine Cooling Areas
Clean (see Engine
Owner’s Manual)
X
Engine Oil
Check (see Engine
Owner’s Manual)
X
Change (see Engine
Owner’s Manual)
X X
Engine Oil Filter
Change (see Engine
Owner’s Manual)
X X
Engine Spark Plugs
Inspect (see Engine
Owner’s Manual)
X
Fuel Filter Replace
X
Fuel Line Check
X
Grease Fittings Refer to page 18
Hardware
Check for proper
tightness
X X
Mower Main Frame
Remove debris from
under belt cover
X
Safety Interlock System
Check Operations
and Switches
X
Tires Check Air Pressure
X
Cleaning the Mower
It is recommended that the BRUSH BEAST mower be cleaned on a daily basis.
Excessive accumulation of dirt, debris, oil, etc., causes premature wear on the
components and may present a potential safety hazard.
Maintenance Schedule
To Next Page
Loading...
