Section 6.
Safe Operation of Your Fire Feature Continued…
6.7) Water Contact
Note: DEKKO supplies vinyl weather covers to help protect your fire feature from rain and
snow. Call our team to purchase yours! (855-422-0077)
• Do not use your fire feature if it becomes submerged in water; call a qualified technician
immediately to inspect the appliance and replace any parts as required
• Do not use fire pit if decorative stones are wet. Allow the fire feature to dry for 45
minutes prior to coming within 15 feet of contact
Section 7.
Maintenance and Care
7.1) Promoting the Longevity of your Fire Pit
• Always ensure that your fire pit is draining water properly and drainage/ventilation
openings are not obstructed by debris
• Cover your fire pit when it is not in use for extended periods of time
7.2) Removing Stains
• Concrete can be cleaned with a mild soap and water solution – never use abrasives or
strong chemicals as they may stain the surface. A spill should be cleaned immediately by
carefully blotting with a paper towel or clean white towel. Do not ‘wipe’ a spill as it may
force the potential stain deeper into the surface. If the stain persists, please contact our
team for further instructions (855-422-0077)
7.3) Sealant
• Sealing your fire pit for additional protection is not required, but if desired, you can seal
the surface with a water-based outdoor sealer that will not yellow over time
PLEASE NOTE: Using anything other than the recommend sealer may void your
warranty as some sealants may cause yellowing and flaking to your fire pit
To Next Page
Loading...