12
Keep the door open while programming to avoid being locked out
accidentally. The lock contains one factory-preset user code but can be
programmed to store up to a total of six additional unique user codes.
˙ Codes can be added and deleted at any time. For first-time programming,
use factory default programming code. It’s recommended to change the
default programming code and default user code right after you install
the lock.
˙
Every programming step should be done within 6 seconds.
OPERATING INSTRUCTIONS
Operation Indicator Sounds and Lights
Sounds
Lights Meaning
Successful Operation
Successful Programming
Operation Error
Code Input Error;
System Shuts Down
Low Battery Power
Default Setting Restored
In Programming Mode
1 Beep
2 Long Beeps
3 Beeps
5 Beeps
10 Rapid Beeps
Lock button flashes slowly
3 Long Beeps
To Next Page
