4
3
4
5
2 3/4" (70 mm)
3. Latch Backset Adjustment
Determine if the latch (D) needs to be adjusted
to the 2 3/4" (70 mm) backset.
To adjust, rotate the latch until it stops.
Reverse the direction to return to the
2 3/8" (60 mm) backset.
4. Mark the Door with Template
Select the height and backset as desired on
the door face; use the TEMPLATE as an
indication to mark the centre of the circle on
the door face and the centre of the door
edge.
5. Drill Holes
Using the marks as a guide to drill a hole
Ø2 1/8" (54 mm) through the door face for
the lockset, then a hole of Ø1" (25.4 mm)
for latch.
D
ASSEMBLY INSTRUCTIONS
To Next Page
Loading...
