Delem DA-65 - Page 234

Delem
V1101, 9.32
9.4.3 Parameters analog part support
Parameter: 7
Min. Value
Range : 0.0 - 90.0
Default : 90.0
Unit : degrees (E)
Function
The minimum angle at which the support arm may be positioned. This is a software limit. See
also adjustment procedure part support parameters.
Parameter: 8
Max. Value
Range : 0.0 - 90.0
Default : 90.0
Unit : degrees (E)
Function
The maximum angle at which the support arm may be positioned. This is a software limit. See
also adjustment procedure part support parameters.
Parameter: 18
DA-min
Range : 0 - 255
Default : 0
Unit : -
Function
Minimum value of AD-converted potentiometer voltage. This value represents the minimum
angle at which the part support arm may be positioned. See also adjustment procedure part
support parameters.